Wearing Parts of Horsch

Maxipart® Disc Cut-away 18” (460mm)

1. Slow press to eliminate disc distortion.
2. Cut rather than pressed bolt holes ensures perfect fitment every time.
3. Outer edge cut onto each disc individually for optimal sharpness.
4. Each scallop individually cut.
5. Optimum hardness ensures extended wear life without cracking.

Levelling Board Tine L575mm x W45mm x T10mm
Height to frame 375mm (Excluding Point)

Eradicator Point 170mm x 90mm x 8mm

By using a specialised High Carbon steel, the C60 range allows for the tines to retain optimum flexibility where needed, whilst heat treating the wear tips so that they reach a hardness in excess of 60HRC.

Resulting in an unrivalled high quality performance with maximum wear life.