Wearing Parts Cultivation and Subsoil To fit Grange Machinery

Maxipart® Grange Point Tungsten (127mm / 5"):

1. The base metal is one-piece cast alloy which presents far better wear properties than a fabricated wear point.
2. Tungsten tiles are applied to the points, wings and shin so that all the working edges are protected ensuring a perfect working shape is maintained throughout its extended working life.
3. Ridges have been added to the wings which helps with soil flow as well as helping extend its life.
4. Hard facing has been added to the top of the shin and to the underside of the point to further extend its working life and prevent excessive wear to the leg.

Maxipart® Front Disc Shallow Cut-away 18” (450mm)

1. Slow press to eliminate disc distortion
2. Cut rather than pressed bolt holes to ensure perfect fitment every time
3. Outer edge cut onto each disc individually for optimal sharpness
4. Each scallop individual cut
5. Optimum hardness ensures extended wear life without cracking

Maxipart® Grange Point - New Leg 200mm Shin Height:

1. The base metal is one-piece cast steel which presents far better wear properties than a fabricated wear point.
2. It has extended tungsten throughout, covering the nose, shins and wings, ensuring a perfect working shape throughout its life.
3. Added ridges to the wings to further improve the life of the wings.
4. With tungsten to the top of the point hardfacing has been added to the rear of the point and below to extend the life of the leg.