Micro Low Profile or Wafer Head Screws

These are extremely suitable for tight spaces and for reducing component weight.

With the miniaturisation of a large number of products, this has become an invaluable addition to the range of  Micro screws.
With a flattened fastening face, this supports layers of parts.

Made from Steel with a Black Coating, this has many advantages.

• Magnetic to facilitate easy holding to the driver bit.

• Black coated to match with most electronic assemblies and light absorption.

• Low profile head for space and weight saving.

• Lengths as short as 2 mm for an M2 screw available.

• Lengths in decimals also available eg. 2.5, 3.5 etc

Applications:

-For flat surface design without head edge
-For smooth appearance design

In installation where the part does not permit deep enough holes to make a countersunk.

Use in Laptops and computers.

Saves space and permits flexible design.

Available in Steel BLACK coated.
Sizes: M1.2 to M3

Low Profile Phillips MC Screw Black Steel A6B16 – Download Datasheet

Usage Guidelines.

• Always keep the tightening torque within the recommended torque range. This will prevent screw and joint failure. Using a torque enabled driver is recommended.

• Check tapped hole with thread plug gauge before assembly to ensure perfect installation.

• Use a good quality Drive bit and check that there is no excessive play before applying torque.